Monatsrückblick Januar/Februar 2026 ist online!

[Rushmed]

Hallo,

in meine iob diag finde ich Folgendes:

*** FAILED SERVICES ***

  UNIT                LOAD   ACTIVE SUB    DESCRIPTION
* nut-monitor.service loaded failed failed Network UPS Tools - power device monitor and shutdown controller

LOAD   = Reflects whether the unit definition was properly loaded.
ACTIVE = The high-level unit activation state, i.e. generalization of SUB.
SUB    = The low-level unit activation state, values depend on unit type.
1 loaded units listed.

Wenn ich versuche zu deinstallieren kommt:

pi@Smartazamba:~ $ sudo apt-get remove nut-monitor
Reading package lists... Done
Building dependency tree... Done
Reading state information... Done
Package 'nut-monitor' is not installed, so not removed
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.

Wie kann ich den nut-monitor.service, bzw. die Meldung loswerden?

[Thomas Braun]

@rushmed sagte in nut-monitor.service entfernen:

nut-monitor

sudo systemctl hide nut-monitor.service

[Rushmed]

@thomas-braun Das hat leider nicht geklappt:

pi@Smartazamba:~ $ sudo systemctl hide nut-monitor.service
Unknown command verb hide.

und

pi@Smartazamba:~ $ systemctl status nut-monitor.service
× nut-monitor.service - Network UPS Tools - power device monitor and shutdown controller
     Loaded: loaded (/lib/systemd/system/nut-monitor.service; enabled; preset: enabled)
     Active: failed (Result: exit-code) since Fri 2024-03-01 19:29:19 CET; 1h 15min ago
   Duration: 97ms
    Process: 660 ExecStart=/sbin/upsmon -F (code=exited, status=1/FAILURE)
   Main PID: 660 (code=exited, status=1/FAILURE)
        CPU: 36ms

Mar 01 19:29:19 Smartazamba nut-monitor[660]: fopen /run/nut/upsmon.pid: No such file or directory
Mar 01 19:29:19 Smartazamba nut-monitor[660]: Could not find PID file to see if previous upsmon instance is already run>
Mar 01 19:29:19 Smartazamba nut-monitor[660]: Using power down flag file /etc/killpower
Mar 01 19:29:19 Smartazamba nut-monitor[660]: Network UPS Tools upsmon 2.8.0
Mar 01 19:29:19 Smartazamba nut-monitor[660]: Fatal error: insufficient power configured!
Mar 01 19:29:19 Smartazamba nut-monitor[660]: Sum of power values........: 0
Mar 01 19:29:19 Smartazamba nut-monitor[660]: Minimum value (MINSUPPLIES): 1
Mar 01 19:29:19 Smartazamba nut-monitor[660]: Edit your upsmon.conf and change the values.
Mar 01 19:29:19 Smartazamba systemd[1]: nut-monitor.service: Main process exited, code=exited, status=1/FAILURE
Mar 01 19:29:19 Smartazamba systemd[1]: nut-monitor.service: Failed with result 'exit-code'.
lines 1-18/18 (END)

[Thomas Braun]

@rushmed
Sorry, mein Fehler.

sudo systemctl mask nut-monitor.service

[Rushmed]

@thomas-braun Danke, das hat geklappt.